M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual do Utilizador descarregar pdf (Página 9)

if you use these in Optical S/PDIF mode, they will also support the higher sample rates of

88.2 and 96 kHz.

Tip

Don’t forget to select the appropriate I/O format as the Clock Source in the Hardware

Setup dialog when transferring material digitally into Pro Tools using ADAT or S/PDIF

formats.

Rear Panel

The Digi 002 has similar connectors on its rear panel to those on the Digi 002R (see

Figure D.10).

At the lower right-hand side, there are four Microphone Inputs through balanced, three-

conductor XLR connectors. If you are using condenser microphones that need to take

their power from the microphone cables, you can switch on the 48-V so-called

“phantom” power for inputs 1 and 2 or for inputs 3 and 4 using two small push-button

switches located above. This 48-V power is then supplied to the microphone through its

own cable.

Also located above the microphone inputs, there are four line/instrument inputs that use

balanced, 1/4-in. TRS jacks for line-level or instrument-level inputs. These line inputs

have operating levels fixed at +4 dBu, which means that they are suitable for connection

to professional audio equipment. To the left of these, there are four more analog inputs

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 70 71

Sem comentários

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual do Utilizador Página 9